How to use MULTIBIC WITHOUT POTASSIUM SOLUTION FOR HEMODIALYSIS AND HEMOFILTRATION
Translated with AI
This page provides general information and does not replace a doctor’s consultation. Always consult a doctor before taking any medication. Seek urgent medical care if symptoms are severe.
Show originalContents of the leaflet
Introduction
Package Leaflet: Information for the User
multiBic without potassium solution for hemodialysis and hemofiltration
Read the entire package leaflet carefully before starting to use this medication, as it contains important information for you.
- Keep this package leaflet, as you may need to read it again.
- If you have any questions, consult your doctor or nurse.
- If you experience side effects, consult your doctor or nurse, even if they are side effects not listed in this package leaflet. See section 4.
Contents of the Package Leaflet
- What is multiBic without potassium and what is it used for
- What you need to know before starting to use multiBic without potassium
- How to use multiBic without potassium
- Possible side effects
- Storage of multiBic without potassium
Contents of the pack and additional information
1. What is multiBic without potassium and what is it used for
multiBic without potassium is a continuous renal replacement therapy solution for the elimination of waste products from the body in people with kidney disease. It is used in patients with kidney injury and also for the treatment of intoxications. The type of solution administered depends on the amount of potassium (a salt) in the blood. Your doctor will regularly monitor your potassium levels.
2. What you need to know before starting to use multiBic without potassium
Do not use multiBic without potassium if
- you are allergic to the active substances or to any of the other components of this medication (listed in section 6).
- you have hypokalemia (your potassium levels are very low)
- you have metabolic alkalosis (when you have too much bicarbonate in the blood).
- you cannot achieve sufficient blood flow through the hemofilter (filter used in blood filtration)
- you have a high risk of bleeding related to the medications needed to prevent coagulation in the hemofilter.
Warnings and precautions
Consult your doctor before starting to use multiBic without potassium
- Do not use before mixing the two solutions in a double-chamber bag (two compartments)
- Do not use if the solution temperature is below room temperature
- The tubing lines used to administer the ready-to-use solution must be inspected every 30 minutes.
If a precipitate (solid matter) is observed within these tubing lines, the bags and tubing lines must be replaced immediately and the patient must be carefully monitored.
- Your doctor will monitor your hydration status (amount of water in your body), potassium levels, sodium levels, other electrolytes, certain waste products, and blood sugar levels. Your doctor may also advise you on your diet.
Children
The use of multiBic without potassium has not been established in children.
Use of multiBic without potassium with other medications
Tell your doctor if you are using, have recently used, or may need to use any other medication.
The following interactions may occur:
- Toxic effects of digitalis (medications for heart disease)
- Electrolyte substitutions, parenteral nutrition (intravenous feeding), and other treatments with infusions. When using this therapy, its effect on serum concentration and fluid status must be taken into account.
- This therapy may reduce the concentration of medications in the blood. A dose adjustment may be necessary.
Pregnancy and breastfeeding
If you are pregnant or breastfeeding, think you may be pregnant, or plan to become pregnant, consult your doctor before using this medication.
There are no data or limited data on the use of multiBic without potassium in pregnant and breastfeeding women.
This medication should only be used during pregnancy if your doctor considers the treatment necessary.
Breastfeeding is not recommended during treatment with multiBic without potassium.
3. How to use multiBic without potassium
multiBic without potassium will be administered to you in a hospital or clinic. Your doctor knows how to use this medication.
If you have any further questions about the use of this medication, ask your doctor.
4. Possible side effects
Like all medications, this medication can cause side effects, although not everyone gets them.
The side effects of multiBic without potassium include:
- nausea
- vomiting
- muscle cramps
- changes in blood pressure
Some side effects may be caused by having too much fluid or too little fluid. These include:
- difficulty breathing
- swelling of the ankles and legs
- dehydration (e.g., dizziness, muscle cramps, feeling of thirst)
- blood disorders (e.g., abnormal salt concentrations in the blood)
The exact frequency of these events is not known (cannot be estimated from the available data).
Reporting side effects
If you experience any side effects, consult your doctor or pharmacist, even if they are possible side effects not listed in this package leaflet. You can also report them directly through the Spanish Pharmacovigilance System for Human Use Medicines: www.notificaRAM.es. By reporting side effects, you can help provide more information on the safety of this medication.
5. Storage of multiBic without potassium
Keep this medication out of the sight and reach of children.
Do not store below 4 °C.
Storage conditions after mixing the two compartments:
The ready-to-use solution must not be stored at a temperature above 30 °C and must be used within 48 hours.
Do not use this medication after the expiration date stated on the packaging after CAD. The expiration date is the last day of the month indicated.
6. Contents of the pack and additional information
Composition of multiBic without potassium
- The active substances are sodium chloride, sodium bicarbonate, calcium chloride, magnesium chloride hexahydrate, and glucose monohydrate.
- The other components are water for injections, 25% hydrochloric acid, carbon dioxide, and sodium dihydrogen phosphate dihydrate.
Appearance and packaging of the product
multiBic without potassium is available in a double-chamber bag (two compartments containing different solutions). Mixing the solutions from the two compartments results in the ready-to-use solution.
Each bag contains 5,000 ml of solution in total. The ready-to-use solution is clear and colorless.
Each bag is equipped with an HF connector, a Luer lock connector, an injection port, and is covered with a protective film.
Package size:
2 bags of 5,000 ml
Marketing authorization holder and manufacturer
Marketing authorization holder
Fresenius Medical Care Deutschland GmbH, Else-Kröner-Straße 1, 61352 Bad Homburg v.d.H., Germany
Manufacturer
Fresenius Medical Care Deutschland GmbH, Frankfurter Straße 6-8, 66606 St. Wendel, Germany
Local representative
Fresenius Medical Care España S.A.
C/ Ronda de Poniente, 8, planta baja, Parque Empresarial Euronova,
28760 Tres Cantos (Madrid)
Spain
Date of the last revision of this package leaflet: March 2025
Detailed and up-to-date information on this medication is available on the website of the Spanish Agency for Medicines and Health Products (AEMPS) http://www.aemps.gob.es
Information intended only for healthcare professionals, see below.
--------------------------------------------------------------------------------------------------------------
The following information is intended only for healthcare professionals:
1,000 ml of the ready-to-use solution contains:
Sodium chloride | 6.136 g |
Sodium bicarbonate | 2.940 g |
Calcium chloride dihydrate | 0.2205 g |
Magnesium chloride hexahydrate | 0.1017 g |
Glucose monohydrate | 1.100 g |
(Glucose) | (1.000 g) |
K+ | - |
Na+ | 140 mmol/l |
Ca2+ | 1.5 mmol/l |
Mg2+ | 0.50 mmol/l |
Cl- | 109 mmol/l |
HCO3- | 35 mmol/l |
Glucose | 5.55 mmol/l |
pH ≈ 7.4
Theoretical osmolality: 292 mOsm/l
Do not use if the solution is not clear and colorless and if the bag or connectors are damaged.
For single use only. Any unused solution must be discarded.
Use only through a pump integrated into the extracorporeal blood purification device.
Instructions for use
The hemodialysis and hemofiltration solution must be administered in three stages:
- Removal of the overbag and detailed inspection of the bag
The overbag must be removed only immediately before administration.
Plastic containers can occasionally be damaged during transport from the manufacturing site to the clinic or within the clinic itself. In the solution, this can lead to contamination and microbiological or fungal growth. Therefore, a careful visual inspection of the bag and solutions is necessary before use. Particular attention should be paid to even minor damage to the stopper, welds, and edges of the bag.
- Mixing of the two compartments
The two solutions must be mixed immediately before use to obtain the ready-to-use solution.
After both compartments have been mixed, it must be verified that the weld is fully open, that the solution is clear and colorless, and that the container does not leak.
- Administration of the ready-to-use solution
The ready-to-use solution must be used immediately, within 48 hours of mixing.
Any addition to the ready-to-use solution must only be made after the ready-to-use solution has been thoroughly mixed. After making an addition, the ready-to-use solution must be thoroughly mixed again before use.
The addition of a sodium chloride solution (up to 30%) or alternatively water for injections is compatible with this medication and can be used to adjust the sodium concentration if necessary to limit the rate of changes in sodium concentration in cases of severe hypernatremia or hyponatremia. For more details, see the technical data sheet.
If not otherwise prescribed, the ready-to-use solution must be warmed immediately before perfusion to 36.5°C - 38.0°C. The exact temperature must be selected depending on the clinical requirements and the technical equipment used.
-
- Country of registration
- Dosage formHEMOFILTRATION, -
- ATC codeB05ZB91
- Active substance
- Prescription requiredYes
- Manufacturer
- This information is for reference only and does not constitute medical advice. Always consult a doctor before taking any medication. Oladoctor is not responsible for medical decisions based on this content.
- Alternatives to MULTIBIC WITHOUT POTASSIUM SOLUTION FOR HEMODIALYSIS AND HEMOFILTRATIONDosage form: HEMOFILTRATION, 2 mmol potassium/lActive substance: HemofiltratesManufacturer: Nikkiso BelgiumPrescription requiredDosage form: HEMOFILTRATION, 4 mmol potassium/lActive substance: HemofiltratesManufacturer: Nikkiso BelgiumPrescription requiredDosage form: HEMOFILTRATION, -Active substance: HemofiltratesManufacturer: Nikkiso BelgiumPrescription required
Online doctors for MULTIBIC WITHOUT POTASSIUM SOLUTION FOR HEMODIALYSIS AND HEMOFILTRATION
Discuss questions about MULTIBIC WITHOUT POTASSIUM SOLUTION FOR HEMODIALYSIS AND HEMOFILTRATION, including use, safety considerations and prescription review, subject to medical assessment and local regulations.
Get MULTIBIC WITHOUT POTASSIUM SOLUTION FOR HEMODIALYSIS AND HEMOFILTRATION Prescription Online
Fill in a 2-min form
Tell us your symptoms, history, and what medicine you're requesting.
Pick a doctor or let us assign
Choose a specialist or we'll match you with the next available doctor.
Doctor reviews your case
Usually within 30 minutes. They may ask follow-up questions via chat.
Collect from any pharmacy
Electronic prescription sent to your email — valid across Spain.
Frequently Asked Questions
MULTIBIC WITHOUT POTASSIUM SOLUTION FOR HEMODIALYSIS AND HEMOFILTRATION requires a prescription in Spain. You can check with a doctor online whether this medicine may be appropriate for your situation.
The active ingredient in MULTIBIC WITHOUT POTASSIUM SOLUTION FOR HEMODIALYSIS AND HEMOFILTRATION is Hemofiltrates. This information helps identify medicines with the same composition but different brand names.
MULTIBIC WITHOUT POTASSIUM SOLUTION FOR HEMODIALYSIS AND HEMOFILTRATION is manufactured by Fresenius Medical Care Deutschland Gmbh. Pharmacy brands and packaging may differ depending on the distributor.
Doctors such as Family doctors, Psychiatrists, Dermatologists, Cardiologists, Endocrinologists, Gastroenterologists, Pulmonologists, Nephrologists, Rheumatologists, Hematologists, Infectious disease physicians, Allergists, Geriatricians, Paediatricians, Oncologists may assess whether MULTIBIC WITHOUT POTASSIUM SOLUTION FOR HEMODIALYSIS AND HEMOFILTRATION is appropriate, depending on your situation and local regulations. You can book an online consultation to discuss your symptoms and possible next steps.
Spain has a well-developed healthcare infrastructure across major cities such as Madrid, Barcelona, Valencia, and Seville. Pharmacies are widely available and operate under strict regulations, ensuring access to prescribed medications.
You can buy MULTIBIC WITHOUT POTASSIUM SOLUTION FOR HEMODIALYSIS AND HEMOFILTRATION in Madrid, Barcelona, Seville, or Valencia at any local pharmacy with a valid prescription.
To obtain a prescription, you can use Oladoctor:
Other medicines with the same active substance (Hemofiltrates) include ACCUSOL 35 POTASSIUM 2 mmol/L SOLUTION FOR HEMOFILTRATION, HEMODIALYSIS AND HEMODIAFILTRATION, ACCUSOL 35 POTASSIUM 4 mmol/L SOLUTION FOR HEMOFILTRATION, HEMODIALYSIS AND HEMODIAFILTRATION, ACCUSOL 35 SOLUTION FOR HEMOFILTRATION, HEMODIALYSIS AND HEMODIAFILTRATION. These may have different brand names or formulations but contain the same therapeutic ingredient. Always consult a doctor before switching or starting a new medicine.
